This site uses cookies. By continuing, your consent is assumed. Learn more

130.4m shares

Pool pump and filter hook up

opinion

Winterizing your above-ground pool requires you to drain the sand filter and the pump. Winterization also requires you to disconnect the hoses for the pool, pump and filter. Once the winter is over, and the outdoor temperatures begin to rise, it is time to reopen the pool for the summer. Trying to remember where each of the three hoses attach to your filter, pool and pump can quickly spell disaster Pool pump and filter hook up you mix up the connections.

Correctly hook up your sand filter and pump to your above-ground pool for hours of summer fun. Place the sand filter close to the pump. Make sure to locate it near the skimmer and Pool pump and filter hook up on your pool. Ensure the ground is level beneath the pump and filer. Place the pump and filter on concrete blocks for additional stability.

Pumps can be hardwired to the breaker, or plug into an outdoor receptacle.

How To Install a Pool...

You may have a separate switch that operates the pump. Regardless of how your pump connects to the circuit, turning off the breaker ensures the electricity is disconnected and allows you to connect the pump to the filter safely.

Slide hose clamps onto each end of your flexible pool hose. Connect one end of the pool hose to the bottom of the skimmer and the opposite end to the inlet port on your pump.

If your model of pool...

Use a screwdriver to tighten Pool pump and filter hook up hose clamps, securing the hose to the skimmer and pump. Connect another hose to the outlet port on your pump. Connect the other end of this hose to the inlet port on your sand filter.

Tighten the hose clamps with the screwdriver. Push the final length of hose over the outlet port on the sand filter. Connect the other end of this hose to the inlet port on the side of your pool.

A swimming pool filter helps...

Turn on the above-ground pool pump. Allow the pump to run for about two minutes to remove any impurities from the silica sand in the filter. Turn off the pump. Pool pump and filter hook up on the pump to operate the filter and pump normally. Cecilia Harsch has been writing professionally since She writes mainly home improvement, health and travel articles for various online publications.

She has several years of experience in the home-improvement industry, focusing on gardening, and a background in group exercise instruction.

Winterizing your above-ground pool requires...

Harsch received her Certified Nurses Assistant license in She attended Tarrant County College and studied English composition. Skip to main content. Tip If your pump and filter hoses use threaded connectors, wrap thread-seal tape around the male threads on the hoses before attaching them to the pump, filter and pool. References 3 Best Buy Pool Supply: About Pool pump and filter hook up Author Cecilia Harsch has been writing professionally since Accessed 17 November Home Guides SF Gate.

Depending on which text editor you're pasting into, you might have to add the italics to the site name. Winterizing your above-ground pool requires you to drain the sand filter and the pump.

If your model of pool...

Winterization also requires you to disconnect the hoses for the pool. When installing the pool sand filter, you will connect it right after the pump. Pool water will come in through the pool pump, be filtered through the sand filter and.

If your model of pool filter has a twinned pipe or union to connect it to the pool pump, attach the correct section to the pool pump.

Use a pair of water pump pliers.

MORE: Parental control software for android

MORE: Amateur grandmother sex

MORE: Christian hookup all over the world

YOU ARE HERE:
News feed